The Jetta is a typical machine trumped-up by German manufacturer Volkswagen. The Jetta has been equipped with a change of engines over the second childhood, including a VR-6, usually aspirated four-cylinders and turbocharged engines. According to any machine, the brakes on a Jetta should be properly maintained to make certain that the vehicle remains unharmed to coerce. The caliper is the stuff on the brakes that is at fault for clamping the rotors, which slows the automobile.
Floor Jack, Jack Stand and Lug Wrench
For you to access a caliper on a Jetta, the vehivle has to be lifted and supported before the circle is removed. This requires a floor jack to lift the Jetta, a jack stand to bedding it and a lug wrench to loosen and remove the lug nuts.
Socket Set and Ratchet
The caliper bracket on a Jetta is secured to the suspension with two broad bolts.
Caliper Piston Retraction Tool
When a Jetta caliper is reinstalled over a advanced locate of brake pads, which are thicker than the stock brake pads, the piston in the caliper -- the part that presses against the brake pad -- has to be retracted into the caliper To admit adequate clearance for the caliper and pads to slide over the rotor. On most VWs and Audis, a special tool is needed for this that allows the piston to be turned and simultaneously pushed into the caliper.A brake wrinkle that delivers the utility of brake fluid to the caliper is connected to the caliper. As the caliper is continuance removed, a line wrench is obligatory to loosen and remove the becoming that holds the column to the caliper. A column wrench is an open-end wrench that goes approximately the stone farther than a morals wrench to cut the chances of accidentally stripping the kernel in circumstances the wrench slips off of it.
A socket and a ratchet is required to loosen and remove these bolts. The caliper itself is bolted to its bracket with Torx-shaped bolts, so a establish of star-shaped Torx wrenches are needed to disconnect the brake caliper from the bracket.
Line Wrenches
The tool has metal dowels that correspond with indentations in the piston that allow it to grip and turn the piston.
Miscellaneous Tools
Other helpful tools and supplies To possess on hand when working on a Jetta's caliper include screwdrivers, pliers (for removing caliper spring clips), rubber gloves and eye protection. It can also be helpful To possess penetrating lubricant to help loosen tight bolts, also as degreaser and rags To cleanse up spilled fluid and grease.
