Sliding glass doors bring in anticipated glossy
Sliding glass doors are typically installed at the exterior of homes as a road to create rooms also accessible to common flare. According to ServiceMagic.com, they can as well bestow a improved conception of a patio, backyard or garden and build rooms drop in larger. Unlike customary doors, sliding glass doors administer by sliding along metal tracks on the floor and are secured by a hook that attaches to a metal plate on the door doorpost. Sliding glass doors are available in many designs with a incongruity of security features.
Instructions
Removing the Door
1. Detach the constant door panel by using a potency drill to remove the two brackets at the top and backside of the door.
2. Slide the constant door panel to the centre, then lift the backside of the door up and away of the tracks.
The flashing protects the wood from baptize damage.11. Evaluation to see if the new siding glass door is the right size by using a tape measure To gauge the door and the opening. According to RonHazelton.com, replacement doors are typically smaller than the original sliding glass door.
5. Remove the nails from the exterior trim of the door frame using a Spike puller.
6. Remove the screws from the beginning using a capacity drill and then pull the doorway absent. Once the commencement is removed, pull the door frame gone from the doorway and dispose of it.
Threshold and Framing
7. Remove any loose or rotted wood from below the mature doorway using a dwarf crowbar and wood chisel.
8. Situate an appropriately sized quota of pressure-treated wood in put as the floor to the doorway. Bag a Spike gun to Spike it in country. Apartment a common on top of the wood to confirm that it is even.
9. Subsume distinct shims along the backside of the wood to supply extra flotation. Then handle a handsaw to chop off the protruding ends of the shims.
10. Situate stage metal flashing over the face of the wood and fold it over the top surface. Custom galvanized roofing nails and a hammer to secure the event metal flashing in district.3. Detach the sliding door panel by first off prying off the retaining strip using a pry bar and then prying off the interior door casing.4. Lift the top of the sliding door panel outside of the frame and then dispose of both door panels.
If the replacement door is smaller, proceed to the next step. If the door is the right size, proceed to the next section.
12. Determine the size difference between the sliding glass door and the top and right side of the opening by using the tape measure. Once you have the measurements, use a saw to chop pieces of pressure-treated wood to size.
13. Nail one appropriately sized piece of wood horizontally across the top of the doorway and the other vertically along the edge of the doorway using a nail gun.
Attaching the Sliding Door
14. Bend out the nailing flange along the top and sides of the frame on the new sliding glass door. The nailing flange is used to attach the door to the house and provide weather sealing.
15. Apply a bead of exterior-grade caulking down the center of the nailing flange on the side of the flange that attaches to the house.
16. Apply a bead of exterior-grade caulking around the entire length and width of the threshold, about an inch from the edge. When you're done the caulking should have formed a rectangle.
17.Place the base of the sliding door along the metal flashing, carefully tipping it upward until it is centered in position and the flange meets the doorway framing.
18. Hold the door frame in place by hammering one nail through the nailing flange at the top center of the doorway.
19. Use a level to be sure the sides of the door are perfectly vertical and then hammer in the remaining nails to secure the sliding door.
20. Replace the top and side door casings that were previously removed.
