Motorcycle speedometers are not tough to repair.
Accepted motorcycle speedometers are not entangled pieces of Accoutrement. They consist of a speedometer gauge and a speedometer cable that connects between the gauge and a becoming on the front revolve hub. Some motorcycles keep electronic speedometers that need calibration and repair by a trained technician. Problems with mechanical speedometers are most repeatedly a defective gauge or worn cable. Provided the gauge is not damaged, a manageable troubleshooting procedure Testament isolate the puzzle.
Instructions
1. Stabilize the motorcycle on the kickstand or a repair stand. Set the lower extremity of the speedometer cable where it attaches at the front wheel hub. Exercise a insufficient metric wrench to loosen the becoming that connects the cable to the hub.
2. Pull the purpose of the cable elsewhere of the hub, and look the square butt end of the cable. Provided it is broken or the edges are rounded, the cable needs to be replaced. Provided the borderline is broken, there is most practicable a portion of the broken speck inside the hub. Appropriateness a sewing thorn or other humble, pointed entity to occupation the broken parcel gone of the speedometer hub. Whether the cusp is not worn or broken, reattach the becoming and proceed To pace 5. Otherwise, earn a contemporary cable and proceed to the adjacent transaction.
Route the cable to the underside of the speedometer and attach the upper end to the fitting on the speedometer. Tighten the fitting with pliers. Reattach the speedometer cable guides. Remove any cable guides on the front forks or the handlebars of the motorcycle. The specific type of motorcycle determines the type of guides and part needed to remove them.
4. Put a small amount of speedometer cable grease on the square end of the cable, and reattach it to the front wheel speedometer hub.3. Loosen the speedometer cable connexion becoming on the underside of the speedometer by turning it counterclockwise with pliers. Pull the deadline of the cable away of the speedometer.
5. Detach the cable from the underside of the speedometer. Use a metric wrench to loosen the nuts on the handlebars that secure the speedometer camp. Remove the speedometer, and place it on a worktable. Use a metric wrench or small screwdriver to remove the back cover from the speedometer. The type of speedometer dictates the correct tool to use.
6. Remove the odometer with a screwdriver or small metric wrench. Inspect the small odometer gears located just behind or below the odometer number wheels. Replace the odometer if the gears are worn badly or teeth are broken.
7. Inspect the back of the speedometer dial and the speedometer gears. If rust or corrosion has accumulated, the speedometer needs to be replaced. Otherwise, spray the components with lubricant and manipulate them by hand to make sure things move freely. Install the existing or new odometer, and reattach the back cover to the speedometer. Position the speedometer in place and tighten the clamp. Reattach the cable at the underside of the speedometer.
