Transform a Motorcar Door Lock Cylinder
The door lock cylinder on a motorcar is not dependable there to protect you and your family, giving you some stillness of genius, however extremely to protect the vehicle itself from theft and anything on the inside. Whenever you turn the chief in the Chauffeur door or passenger door, the door's catch mechanism should either lock or unlock the door. On the contrary, a worn-out cylinder can fabricate it solid to lock or unlock the van door. In uttermost cases, the cylinder Testament either not Proceeds the leading or author the pivotal to cleft off in the cylinder.
Instructions
1. Unlock the door where you Testament be replacing the door lock cylinder, using your main or the inside door lock. Roll up the machine window with the Eccentric person or practice the door panel Press-stud. Push the ends of the C-clip located remain the door stock off the window ear using a window apply puller. Remove the window grasp from the bar.
Remove the inside door panel by prying the clips out with a flat-head screwdriver, starting at the lower corners and working your system back environing to the top of the door panel.3. Pull off the bracket clip holding the lock cylinder in put with a duo of needle-nose pliers by sliding one of your hands up to the back of the lock cylinder. Pull the lock cylinder away of the door from the outside (push from the inside if needed).2. Unscrew the door lock indicator (used to lock or unlock door manually) adjacent to the window. Remove the Ending screws from the door shaft tray and armrest.
Remove the piece that connects the cylinder to the lock indicator stem by pulling up the three small tabs that attaches to the remaining smaller bracket from the back of the lock cylinder with the needle-nose pliers.
4. Assemble the new door lock cylinder like the old one by putting the rubber gasket on the part of the cylinder that fit on the outside of the car door. Push the new small bracket on the cylinder to hold the gasket in place. Put the complete lock assembly into the hole in the door and align with the cylinder slot.
5. Place the big bracket that holds the door lock cylinder tight to the inside of the door. Test the new door lock cylinder by locking and unlocking the door using the new cylinder.
