Custom entity drudge is one expedient to cook your drive stand outside from remainder. From immense flash spin wells to dramatic spoilers and marvelous grill chore, there are legion ways To erect your vehivle into one of the most eye-popping machines on the method. All you keep to effect is compose your own reason shapes using forms and fiberglass moulds. It is a formation that takes a portion of bit, skill and sweat, however the rewards are tremendous.
Instructions
Building the Molds
1. Envision your custom parts and construct an exact portrayal on paper or finished a 3-D personal computer graphics programme provided you keep access to one. If the body work involves an enclosed sphere, you will need to make two molds, or cut your fiberglass in half to receive it off the mold.3. Build your mold using a combination of wood braces, foam and screws. You need to shape your mold to the exact shape of the body work part.
The inducement life, you Testament compass to transfer this faculty into a three dimensional shape To erect your mould.2. Decide how many mold parts you will need To erect to create your piece of custom body work.
For example, if you are building a motorcycle fender, you need to create an arced tube to lay the fiberglass around, so sculpting it out of foam is probably your best bet.
4. Detail your mold until it is exactly the way you want it. Remove any imperfections on the surface, because they will all be transferred right to your fiberglass work. Sand down the mold until it is as smooth as you would like the part to be. Add any embossing or debossing during this stage.
Coating the Fiberglass on the Mold
5. Lay out your mold on a work bench or table on a newspaper or a table cloth .
6. Cut enough fiberglass strips to completely cover the mold and create your body part.
7. Mix up your mold release compound and apply it liberally to the mold.
8. Mix your resin compound in a large bowl. Make enough to last through the entire application. You will go through a lot of this stuff, so measure out plenty.
9. Layer your strips onto the mold, covering the piece evenly and entirely. These strips will create the base for your piece, so lay the strips out carefully and be sure they are in the right position. Smooth them all out before you begin the resin application.
10. Apply the resin over the strips, liberally using a brush or spatula. Cover the entire fiberglass strip with enough resin to harden and solidify the strips in an even application.
11. Let it dry and then remove the new body part using a soft rubber mallet. Start on one corner and gently pry the part off the mold. It should come free rather easily.
