Rotors, and avowed as brake discs, alone longing to be replaced whether they entertain worn down or warped. Whether the rotors in your Honda Prelude can't be resurfaced, then it's allotment to swap them away for current ones. The fashion is quite not difficult and you can complete it in your own garage.
Instructions
1. Dispose cutting edge rotors for your Honda Prelude. When replacing rotors it is recommended that you replace all the rotors at once to avoid uneven wear.
Then lower your car, tighten and torque the lug nuts and refill the brake cylinder with new brake fluid. Road test your Honda prelude to make sure that the installation was successful.
Remove the tire and wheel assembly. Remove one of the caliper bolts and rotate the caliper. Take off the mounting bracket for the brake line, but do not disconnect the brake line. Suspend the free caliper with mechanic's wire to prevent straining the brake line.
4. Unfasten the holding screws and then remove the old rotor. Be sure to clean off the oily coating on the new rotor before replacing it.
5. Install the new rotor onto the hub. Replace the rotor holding screws. Push the piston back into the cylinder wall and put the caliper and attached brake line back into place. Tighten and torque the caliper mounting bolts.
6. Replace the tire and wheel assembly. Repeat these steps for each set of rotors.2. Bleed the brake line from the master cylinder by about two-thirds to prevent overflow. Support your vehicle with jacks and jack stands to prevent it from rolling when working on the rotors.3.
