The headliner is one of the features of a vehicle's interior that typically goes unnoticed until there is a doubt. Over clock, top heat, brisk or humidity can justification the foam backing of the headliner info to hole apart, which allows the essence to hang downward. Sagging textile is not by oneself aggravating, however it may fall far Sufficiently to barricade the Chauffeur's seeing, creating a safety subject. Repairing a sagging headliner is a straightforward engagement, nevertheless removing the headliner board from the vehicle may be a inappreciable tricky.
Instructions
Removing the Headliner Board
1.6. Scuff the headliner board lightly with 500-grit sandpaper or a hard-bristled brush until you hold removed all of the foam backing from the headliner board. It is okay whether the board remains slightly sticky, you simply require all of the antiquated foam off the board. Brush the headliner board with a Disinfected, lint-free cloth.
2. Recline the front seats as far back as they Testament birr, provided relevant, and fold down the rear seatbacks whether your vehicle has folding rear seats. Provided your vehicle does not include folding rear seats, remove the rear seat-back cushion and any supporting frame latest it. Regulate all of the vehicle's doors and the Timber or hatch. This gives you maximum Stirring time. Stirring the headliner board encircling the cabin can be awkward.
3. Pull the headliner board downward with the advice of an assistant. Controller the headliner board on ice the vehicle and absent the Timber or one of the doors -- wherever there is the most clearance. The headliner board Testament bend a embryonic, nevertheless don't bend it Sufficiently to account a crease.
4. Allot the headliner board on a rigid and Apartment lodgings surface, with the cloth side facing up, in a well-ventilated sphere.
Preparing the Headliner Board
5. Pull the experienced headliner cloth from the headliner board.
Remove all trim pieces or other components securing the headliner board to the vehicle. This formation varies eminently between vehicles, so evaluate your specific vehicle to gem the trim pieces and components that you'll occasion to remove. In most cars these pieces carry the support trim, roof handles, quarter-panel trim, front windscreen moulding, rear window moulding, sun visors and dome burnished.
7. Settle the new foam-backed fabric onto the headliner board, foam side toward the board, and cut the material in the outline of the headliner board, using a razor utility knife with a new blade. Cut holes in the fabric where the holes are in the headliner board. Change the blade on the knife the instant you feel any drag, because these cuts must be as precise and clean as you can make them. Pull the foam-backed fabric off the headliner board.
8. Spray the headliner board with a liberal coat of spray upholstery adhesive and immediately lay the foam side of the foam-backed fabric onto the adhesive-coated headliner board, being careful to position it precisely.
9. Press downward around the entire area of the foam-backed fabric, using a medium- to large-size textbook or other heavy, flat object.
10. Allow the adhesive to set for the amount of time specified by the can's instructions.
11. Tug lightly around the perimeter of the headliner to guarantee the glue fully adhered it to the headliner board. If any edges come up, simply spray a small amount of spray adhesive under that edge, press it down and allow it to set.
Reinstalling the Headliner
12. Guide the headliner board back into the vehicle's cabin, with the aid of your assistant, via a door or the trunk.
13. Lift the headliner into place, guiding any wires through their respective holes in the headliner.
14. Reinstall any removed trim, handles and dome light to secure the headliner into place. There are no clips or fasteners that secure headliners, just the trim panels.
15. Reinstall the seat back braces and seat-back cushion, as needed.
