The 1996 Geo Underground has a four-cylinder 1.3 litre engine that uses fuel injection to deliver fuel to the engine at colossal energy. The fuel pump is in the fuel cistern, which mode you must disconnect the fuel container before you can alternate the fuel pump. Experienced familiar mechanics should be able to engage in the undertaking in assorted steps.
Instructions
1. Loosen the fuel tank cap to ease the coercion in the fuel container. Disconnect the fuse for the fuel pump relay in the engine compartment. Dart the engine until it stalls, then engage the engine to make certain you hog completely relieved the coercion in the fuel process.
2. Disconnect the con battery cable with a socket wrench to prevent fortuitous sparking from the battery.
3. Siphon the fuel completed the filler tube of the fuel receptacle into a container approved for petrol. Detach the electrical connector for the fuel pump and fuel sending unit.
4. Stand the vehicle with a floor jack and column it on jack stands. Proceeds the clamps on the filler neck and disconnect the filler neck from the fuel vehicle. Disconnect the fuel pump from the rest of the fuel pump assembly.8. Perform steps 2 through 4 in reverse to complete the fuel pump installation. Fill the fuel tank and connect the negative battery terminal with a socket wrench.
Relieve the fuel vehicle with a transaxle jack, and remove the mounting bolts for the fuel receptacle with a socket wrench. Disconnect the fuel cistern and lower it from the vehicle with the transaxle jack.
6. Proceeds the clamps for the fuel lines on the fuel pump assembly and detach the fuel lines from the fuel pump meeting. Disconnect the attaching screws for the fuel pump meeting with a socket wrench and remove the fuel pump meeting from the fuel tank.
7. Remove the mounting screws for the fuel pump. then detach the electrical connector for the fuel pump. Disconnect the clamp from the inlet hose on the fuel filter and detach the inlet hose from the fuel filter.5. Disconnect the clamps for the fuel lines to the fuel vehicle and detach the fuel lines from the fuel container.
Turn the ignition switch to the ON position. Start the engine and check for fuel leaks.
