Friday, October 17, 2014

Switch The Starter Inside A 1994 Chevrolet Cavalier Z24

Reinstall the wiring and splash shield.6. Hoist the motorcar off the stands, remove the stands, and lower the motorcar to the ground. Starter replacement procedures for cars with either transmission is the alike. The well-equipped at rest mechanic can plentiful this repair in approximately 30 minutes in most cases.


Instructions


1. Employ the parking brake and block the rear wheels with the rotate chocks. Lift and facilitate the front of the vehivle using the floor jack and jack stands. Position the jack stands under the front sub-frame before lowering the motorcar on them to base the weight of the Cavalier safely.


2. Disconnect the denial battery cable by removing the 8 mm cable bolt using a wrench. Position the cable so that it can not bring about contact with the battery publish during the repair.


3. Remove the plastic transmission splash shield, which covers the nose of the starter, by removing the two 10 mm bolts that attach it to the transmission bell-housing using a 10 mm wrench. Remove the 9/16-inch kernel that attaches the beneficial battery cable to the back of the starter solenoid using a wrench. Remove the 3/8-inch peanut that attaches the vocable wire to the back of the starter solenoid using a wrench.


4. Remove the 10 mm bolt that attaches the starter brace to the back of the starter. Remove the two 9/16-inch starter bolts that attach the starter to the engine block. Lower the starter to the ground and slide it from under the machine.


5. Lift the cutting edge starter into apartment, and install the two starter bolts, and the facilitate bracket bolt. Torque the three bolts to 66 ft-lbs using a torque wrench.The 1994 Cavalier Z24 came equipped with a 3.1 litre V-6 engine rated at 140 horsepower. This van was as well equipped with either a 5-speed handbook or an optional automatic transmission. As these cars carry forward to period, replacement of ornament parts such as the starter carry incline amassed customary.


Reconnect the negative battery cable, and start the car to verify that the starter functions properly.