Installing electric brakes on your trailer Testament reduce your stopping distance.
Trailer brakes are required in some States depending on the weight of the trailer. There are two types of brakes. Surge brakes rely on the stopping forces generated by the vehicle. These labour beefy for bright loads on the contrary an electrically controlled action is greater. Installing electric brakes is a mild transaction for most trailers. Before you invest in a braking manner test that your trailer has the required flange to mount the brakes. This Testament be a square metal bracket located ultimate the trundle hub.
Instructions
1. Chock the left side turn and jack the appropriate side axle up with the automobile jack. Field the jack stand under the axle and adjust it until supports the axle and rotate off the ground.
2.6. Install the elsewhere bearing back into the hub and push the hub onto the axle. Secure the hub with the centre nut and lock that in place with the cotter pin.
Slide the hub off the axle.
4. Observe to examine whether there is a square flange with bolt holes on Everyone corner endure the hub. Whether there is not, you can't install electric brakes on your trailer.
5. Slide the go side electric brake on the hub and bolt it into deposit using the four holes in the flange. Cook up certain these bolts are tight. Attach the lip seal to the spindle and slide the inside bearing into this seal.
Remove the shove lugs with the socket allot and receipts the rim off the hub. Pry off the protective cap over the centre of the axle with a slotted screw Chauffeur.3. Remove the cotter pin and loosen the bolt which secures the hub to the axle. The nut which secures the hub must allow for the movement of the hub.
7. Tighten the brakes using the tension bolt at the rear until the brake can't move. Then back that bolt off until the brake just slightly rubs.
8. Apply grease into the hub using the grease nipple on the end. Bolt the rim and tire back onto the hub, tightening the bolts in a star pattern. Repeat steps one through eight for the left side brake.
9. Follow the wiring diagram provided with the brakes to associate them to the trailer's electrical connector.
