Preventing corrosion Testament corrective a battery latest.
Battery terminal corrosion is one of the relevant causes of untimely battery failure. Seeping battery acid Testament body up a ashen, yellowish or grassy (or a alloy of all three colours) corrosive powder on the battery terminals that is highly caustic. Moreover, it Testament hinder the electrical connexion needed for the starter, and the battery Testament not discharge on want.
The great battery terminal normally has a blush battery wire, on the other hand there Testament again be a POS, or a plus indication, stamped on the battery casing, near the terminal clamp. Remove the clamp.3.
2. Loosen the worthy battery terminal clamp. Cause a wrench to loosen the aficionado, until the terminal clamp can be wiggled back and forth.
Instructions
1. Deposit on a brace of safety goggles and a fix of durable latex gloves, and unlocked the hood.Perform System 2 on the adverse battery terminal clamp. Removing the clamps in this fashion (confident headmost, contravening last) will help prevent sparks from occurring. Batteries can emit slight-to-moderate amounts of highly flammable gases that can ignite and cause a serious- to-fatal explosion. Isolate both the terminal clamps, so they do not accidentally come into contact with the battery posts during the procedure.
4. Mix a half cup of baking soda with a cup and a half of warm water, and stir the solution to dilute the baking soda.
5. Clean the corrosion off the battery terminal clamps, thoroughly, with the wire brush and the baking soda/water solution, and clean the battery posts in the same fashion.
6. Apply a moderate level coating of petroleum jelly to the cleaned battery terminal clamps, after they have thoroughly dried. Apply another coat of the jelly to the battery posts. Battery corrosion inhibitor spray is also acceptable. If using the spray, apply an even coat to the clamps and posts, and allow the spray to dry.
7. Reconnect the positive terminal clamp first (the procedure to prevent sparks is opposite of the removal procedure). Tighten the clamp with the wrench. Reconnect the negative terminal clamp last, and tighten.
