The Chevrolet Enterprise remote-programming sequence is trickier than most GM vehicles. This is being the Dare uses a altered keyless-entry personal computer, In spite of sharing many components with other GM vehicles. The Plus, LS, LT and Warner Brothers trim levels in the 2000 Chevrolet Endeavor are equipped with the works keyless-entry pc. Whether your Experiment is the pattern example, it does not keep the Accoutrement to synchronise with a keyless-entry remote.
Instructions
1. Turn off the engine. Enter the Dare ended the passenger-side door. Pull off the fuse panel on the genuine side of the glove box.
2. Glimpse for the "BCM Programme" fuse. BCM stands for "Intent Governance Module." Remove this fuse from the block to set off the programming sequence.4. Insert the key into the ignition. Turn the key back one notch to Accessory mode ("ACC"), and then turn it forward to "Off" then back to "Acc."5.
Step out of the vehicle and close the passenger-side door. Verify the other doors, including the liftgate, are closed. Enter the Venture through the driver-side door; close it behind you.
The fuse is located on the front side of the block. End the diagram on the fuse panel whether you enjoy trouble finding it.3.
Open, then close, the driver-side door. Hold "Lock" and "Unlock" on the remote simultaneously. Release both buttons after you hear two beeps. This takes about 14 seconds; the beeps are about seven seconds apart.
6. Turn the ignition off and remove your key. Open the passenger-side door. Reinsert the "BCM Program" fuse to finish.
