Habitual replacement of drum brakes helps cinch your safety.
One of the most critical systems on your Civic is its brakes. Failure to preserve the brakes on your Civic can abundantly power your safety besides as others on the method. Affection many cars, the brakes used on the Civic's rear wheels are drum brakes. This is a braking development where the brake pads are located inside a drum and push absent against the drum when the brakes are busy. You can interchange the drum brakes yourself with the appropriate tools and practice.
Instructions
1. Stadium the Civic on a trustworthy, Apartment lodgings surface. Engage the emergency brake and shift the van into "Grassland" provided it's an automatic or in moment gear whether it's a stick shift.
2. Loosen the lug nuts on the rear wheels nevertheless close not remove them.
3. Stand the rear of the Civic with a jack and community jack stands underneath the outer frame. Slowly lower the motorcar onto the jack stands.
4. Remove the lug nuts from the rear wheels with a lug kernel wrench and obtain the tires off of the machine. Attempt on one side of the vehivle from this aim forward.
5. Screw two 8 mm bolts into the holes on the front of the brake drum. Exchange turning Everyone bolt two revolutions at a clock until the brake drum comes off of the turn hub.
6. Disinfected the brake drum and rotate hub with brake wash. Wear safety goggles and gloves and avoid manage contact with the dirt from the brakes as it may encompass asbestos.
7. Disconnect the springs that grasp the brake pads onto the trundle hub. Commencement with the backside spring: press down on the spring and turn the pin that holds the shoes in field with a screwdriver and a pair of needle-nose pliers.
8. If the hardware is too damaged to use the pliers on it, grind it off with a Dremel drill but do not grind down the pin.10. Clean the wheel hub with brake wash. Apply brake grease to the locations on the wheel hub where the brake shoes make contact.
Remove the front brake shoe from the wheel hub. Disconnect the rear brake pad from the parking brake cable.9. Remove the U-clip that connects the parking brake arm to the brake shoe by prying it off with the needle-nose pliers.
11. Slide the new brake pads into position on the wheel hub.
12. Reassemble the brake by reversing the process that you used to disassemble it. Repeat this procedure on the wheel on the other side of the car.
13. Remount the tires onto the wheel hubs then tighten the lug nuts with the lug nut wrench.
14. Raise the Civic off of the jack stands with the jack, remove the stands then slowly lower the car to the ground.
