A leaking Gauze receptacle is a big disputed point in whatever vehicle you are using. This is amassed than condign losing and wasting fuel; owing to your vehicle generates a quota of heat on the gone, the risk of charring is a excellent opportunity. Gauze tanks always retain a risk of leaking due to rust and corrosion. You shouldn't patch conscientious the happening leaks; you call for to deal with other weak spots that can emerge as leaks.
Instructions
Removing the Tank
1. Benefit the fuel strength. Remove the fuel pump relay from the fuse box, then exit and dash the vehivle until it stalls--this should hire solitary a uncommon seconds. Disconnect the adverse battery cable.
2. Remove the fuel from the vehicle. Provided you don't annex the allotment or don't finish sheltered Sufficiently to fall the motorcar until the Gauze runs absent, utilize a vacuum-based siphoning apparatus to remove the Gauze. Disconnect all accessible fuel lines and electrical connectors from the container; the lines should employment quick-connect Trimmings where you depress the tabs. Lift a floor jack under the vat (operate a block of wood to keep from damaging the tank further), unbolt the tank's straps with a wrench, lower the tank and disconnect all other connectors.4.
Never siphon elsewhere a container by mouth.3. Remove the vehicle from the vehicle.
Remove the fuel pump from the tank if it is installed within it. Depress the pump assembly's locking tab with a pointed tool and rotate the retaining ring with a set of vise-grip pliers. Tilt the fuel pump module slightly as you pull it out of the tank.
5. Pour out whatever is left of the fuel--if you didn't siphon all of it out at first--into the same gas can into which you deposited remainder of the fuel.
Patching the Tank
6. Remove any Velcro rubber straps from the tank. Sand away the paint from the tank's bottom surface with sandpaper and remove the skid plate from the middle using a flat tool. You should now see all leaks and weak spots on the tank.
7. Ream out all leaks and weak spots using a sharp pick, cleaning out all rust and corrosion in the area. This can take some effort, especially if you need to drive the pick all the way through the metal tank.
8. Apply gas tank sealer putty to all the holes and weak spots on the tank, using as much as you feel is needed to completely seal them up. Check the putty's instructions for how long the putty needs to dry.
9. Reconnect the skid plate to the tank using the same putty. Repaint the tank's bottom surface, applying the primer to the surface first and then the paint. Using a paint made for vehicle underbodies.
10. Attach the tank back onto the vehicle in reverse order of removal. Refill the tank, then reconnect the fuel pump relay and negative battery cable. Pressurize the fuel system by turning the key to the "on" position for two seconds and then back off for five seconds; repeat this several times.
