The Ford Engine Corporation designed the full-sized Broncos with a detachable hardtop, with the exception of some early-model Broncos that had an optional welded hardtop. The detachable hardtop was not available on any of the Bronco II models. The hardtop attached to the thing wound up a symbol of top-to-body bolts concealed by interior trim strips. Weatherstripping sealed the top to the protest and preserved the waterproof honorableness of the joints. Remove the trim retaining screws from the trim pieces environing the interior of the top-to-body joints and the top-to-roof Seam using a Phillips-head screwdriver. Pull the trim off the joints.3.
Roll the rear window into a fully-lowered position in the tailgate. Lower the tailgate.
2. The top can be removed using help tools, nevertheless for of the weight and Mass of the top, helpers are fundamental to safely remove it from the thing.
Instructions
Removal
1.Scribe sorrounding the mounting brackets with an Brad-awl to help in locating the mounting brackets during reassembly.
4. Remove the roof bolts using a 5/16-inch socket and ratchet. Remove the mounting brackets and classify them using a felt-tip marker so Everyone bracket can be reinstalled in its aboriginal position.
5. Disconnect the third brake light electrical connector from the vehicle wiring near the reason brake lights.
6. Detraction the two-by-fours on Apartment lodgings ground, duplicate and approximately 1 foot apart, creating a platform to get the roof.
7. Lift the roof off the thing with the work of your helpers. Modification the roof to the platform and allot the roof down on the boards, perpendicular to the method of the boards, to prevent deformation of the roof lip and damage to the weatherstrip.
Installation
8. Install the mounting brackets. Arrange the brackets are in their authentic positions using the labels and scribe marks.
9. Allot the roof in position on the item. Exercise caution to avoid damaging or displacing the weatherstrip.
10. Install the roof bolts. Tighten the short bolts to 13 to 20 foot-pounds and the long bolts to 7 to 10 foot-pounds using a foot-pound torque wrench and 5/16-inch socket.
11. Connect the third brake light electrical connector to the vehicle wiring.
12. Install the trim and trim screws. Tighten the trim screws securely using a Phillips-head screwdriver.
