No tools are needed to copper any of the lights on a 2003 BMW 530i.
The 2003 BMW 530i comes equipped with mucho lights. The headlights, the parking lamps, the turn signals and the brake lamps are all primary safety features on the 530i. Whether any of the lights burn absent, you should convert them at once to prevent accidents. No tools are needed to exchange any of the lights on this BMW; you simply compulsion a replacement bulb. Contradistinctive bulbs are used, depending on the speck, on the other hand all of the bulbs can be purchased from almost any Car servicing store.
Instructions
Halogen Headlights, Parking and Standing Lamps
1. Turn off the engine on your 2003 BMW 530i whether it is running. The backup lamps use W 16 W bulbs. The other lamps use P 21 W bulbs.17.Place the holder back into the tail-lamp assembly and reattach the carpet, if one is installed Close the trunk and then close the hood.
Turn the inner bulb holder to the left to remove the high-beam bulb.
3. Pull the bulb gone of the socket and install a contemporary H7 bulb in its habitat.
4. Reinstall the bulb holder to its initial position and quick the hood.
Front Turn Signals
5. Turn off the automobile engine whether it is running. Situate on the gloves and ajar the hood.
6. Turn the turn-signal bulb holder to the left to remove it. The turn-signal bulb holder is the smaller of the three bulb holders on the headlight meeting.
7. Exercise slight force to the bulb while rotating it counterclockwise to remove it.
8. Install a latest PY 21W bulb in the holder and put the holder back in the meeting. Rotate clockwise to secure it. Hurried the hood.
Side-Mounted Turn Signals
9. Turn off the engine whether it is running and lay on the gloves. Push against the top string of the meeting with your finger. Pull it to the rear to Proceeds it.
10. Rotate the meeting counterclockwise to remove it.
11. Pull the bulb absent of the meeting and install a contemporary W 5 W bulb in its settle.
12. Abode the meeting back into the vehicle and snap it into abode.
Tail Lamps
13. Turn off the engine provided it is running. Deposit on the gloves and exposed the Timber. You Testament notice four lamps on the tail-lamp assembly: the turn signal lamps, tail lamps, brake lamps and backup lamps.
14. Remove the carpet from the trunk if your vehicle comes equipped with one. This will reveal the tail-lamp assembly.
15. Remove the desired bulb holder. The top lamp is the turn signal lamp, the middle lamp is the tail lamp, the bottom lamp is the brake lamp and the bottom corner lamp is the backup lamp.
16. Remove the bulb from the holder and install a new bulb. Settle on the gloves and frank the hood.2. Turn the outer bulb holder to the left to remove the low-beam headlight.
