Lift the Chevrolet Silverado with the jack and corner it on jack stands.2. Remove the wheels with a lug-nut wrench and place them aside.
Rather than precipitation over a lucid brake faculty, receive the hour to function the brakes properly to maximize braking efficiency and brake growth.
Instructions
1.
Set Sticking Brakes on a SilveradoDragging brake pads on a Chevrolet Silverado Testament basis the pads and rotors to prematurely wear. When replacing brake pads, there are a rare matters you should determine to make sure the pads and rotors posses the longest enthusiasm as credible.3. Remove the caliper with a ratchet and employ a bungee cord to hang the caliper. Engage in not let the caliper hang from the brake hose as it might gash and doer fluid to leak.
4. Pull the brake pads gone of the brake caliper bracket. If they don't come out easy, you can use a flathead screwdriver to pry between the brake pad and the rotor.
5. Sand the brake pad holder with 500-grit sandpaper until you see bare metal. If any corrosion remains on the holder, the brake pad will stick.
6. Sand the edges of the brake pad where it makes contact with the brake pad holder. Sand until it is smooth.
7. Place the brake pads back into the brake caliper bracket.
8. Remove the pins from the caliper and clean them of any grease. Place new brake anti-seize onto the pins and put them back into the caliper.
9. Open the master cylinder reservoir so you don't break a seal while compressing the brake caliper.
10. Compress the brake caliper with a C-clamp so the caliper can fit over the new brake pads. Install the caliper by securing it to the brake caliper bracket with a ratchet.
