Provided your van is covered with inconsiderable dents and dings, it may be potential to remove them without modifying the gloss or removing the object panel that needs retouching. Dent Emigration can be done in many ways. One of the cheapest and most accessible methods is to avail compressed air to rapidly nickels the surface temperature of the body panel and goal the dent to pop gone.
Instructions
4. Allow the body panel to cool down and watch the dent reverse itself and conform to the factory lines of the body panel.
Turn the air duster upside down so that cold carbon dioxide (CO2) gas is dispensed when you pull the air duster's trigger.
3. Spray the CO2 gas directly onto the body panel on and around the dented area. When you are done, it will look like the dented area has been frozen.
1. Heat the dented area using the hair dryer. Effect this for approximately 30 seconds to one minute, holding the hair dryer encircling two to three inches gone from the surface of the dented area of the body panel.2.
