A machine suspension equipment varies widely according to the cause and representation of your machine, and very by the mark of your specific suspension adjustment. Off-roaders Testament credible hankering a suspension implements that can use the rigours of Rough driving, while classic van enthusiasts may desire the instruments that peak matches their sweetheart impel. A sporadic basic parameters sincere all machine suspension kits, so chase these steps.
11. Attach the new shocks to the lower mounting points, and tighten the nuts and bolts.12. Take the car to a repair shop to check the alignment.
2. Jack the motorcar up far Sufficiently off the ground so that you can install the suspension apparatus safely.
3. Remove the nuts from the lower shock mounting stud on Everyone trundle. Set them carefully aside in a place where they won't be lost.
4. Detach the shock from its mount as gently as possible. If you're lucky, it will come off easily. If not, you may need to use a hammer or similar heavy tool to coax it.
5. Disconnect the studs holding the leaf-spring mounts to the frame and set them aside. Make sure you keep them separate from the nuts you removed from the lower shock mounting.
6. Loosen the U-bolts and remove them from the frame, followed by the leaf springs and mounting brackets.
7. Replace the new suspension springs on the mounting brackets.
8. Remove the old bushings from the car frame and replace them with new ones.
9. Reinstall the leaf springs, using new bolts if necessary. Depending on rust and corrosion, the old bolts may no longer be stable.
10. Reconnect the U-bolts to the frame.
Instructions
1. Disconnect the con terminal on the machine's battery. This is done for safety reasons, as it Testament prevent the opportunity of suffering an electric shock.Alternately, drive the car on safe streets (residential areas or places with a low speed limit), then raise it again on the jacks and check to make sure all the hardware is still in place.
