Removing the rear operate shaft from your 2000 Toyota Tundra to tow the Motor lorry Testament prevent wear and damage to the transfer occasion, transmission and other driveline components. Running from the rear axle to the rear of the transfer situation, the coerce shaft Testament spin anytime the wheels are turning and, as such, energy the components inside the transfer case or transmission to spin. These components Testament wear as they spin and may not properly lubricate the bearings, causing damage to them. Removing the driveshaft is a deluxe preventative degree when towing your Tundra.
5. Remove the jack stands from under the Motor lorry and carefully lower your Tundra to the ground. Set the parking brake until you are ready to move the truck because without a driveshaft, the transmission can't keep it from rolling or moving.
Fix the Motor lorry down on the jack stands, then remove the jack from under the Motor lorry.
2. Establish the driveshaft in the centre of the rear axle housing under the Motor lorry. Acquisition the four mounting bolts on the rear mounting flange and remove them with a wrench. Pull the driveshaft off the mounting flange and situate it on the ground carefully.
3. Supersede the driveshaft up to the transmission and jewel the four mounting bolts on the flange there. Remove the mounting bolts with a wrench, then pull the driveshaft chargeless from the mounting flange. Carefully remove the driveshaft from under the Motor lorry.
4. Wrap the U-joint caps with electrical tape to clench them on the U-joints while the driveshaft is elsewhere of the Motor lorry. Position the jack back under the Motor lorry and uplift it off the jack stands.
