If you used a clean drain pan, you can use the same coolant. If you didn't, then you need to add new coolant.14.
Instructions
1. Prepare your Tacoma. Stand the hood of the Motor lorry by pulling the lever under the the Chauffeur's side sprint. Then, lift the hood and secure it in community. Disconnect the denying battery cable, Stirring it to the side, nevertheless not allowing contact with any metal.
2. Then shift the compressor and power steering pump back into place.11. Put the fan shroud and clips, along with the fan and pulleys back into place.
3. Remove propel girdle. Using a socket wrench loosen the swivel and adjusting bolts, also as the nuts to the fan pulley, nevertheless don't remove them. Then pull the coerce cummerbund off.
4. Hire off the air conditioning girth. Remove the loafer pulley seed and the adjusting bolt. Then, obtain off the air conditioning zone.
5. Remove alternator guide sash. Give back and remove the centre and adjusting bolts. Then, returns off the fan shroud and clips, along with the fan and pulleys. Modification the influence steering pump and the compressor on the contrary create not disconnect them. Adjust confident the lines don't come off the compressor when you move them to the side.
6. Remove timing belt cover. Remove the six bolts holding the cover in place and set them aside.
7. Remove cylinder. Remove the top dead center (TDC) cylinder, compression stroke and cam shaft. You also need to remove the timing pulleys, thermostat and cooler box. Put all of these parts to the side until you are ready to put your vehicle back together.
8. Remove water pump. Untwist the seven bolts that hold on the water pump, and set them to the side so you don't lose them.
9. Install water pump. Put the new gasket and the new o-ring on using gasket sealant to ensure a tight fit with no leaks. Then, install the new water pump by screwing the seven bolts you removed back into place.
10. Replace the cooler box, thermostat, timing pulleys, cam shaft, compression stroke and TDC cylinder. Reattach the timing belt cover. Filter the radiator fluid. Corner a Disinfected filter pan under the radiator and turn the empty plug allowing the coolant to bleed. Then, remove the upper radiator hose.
Reattach the pivot and adjusting bolts. Then, put the alternator drive belt back on.
12. Put the air conditioning belt back on. Then, reattach the idler pulley nut and the adjusting bolt. Then, put the drive belt back on.
13. Add coolant. Close the drain plug and remove the drain pan. Add coolant to the radiator.
The flood pump plays a cardinal role in the longevity of the Toyota Tacoma V6 3.4L engine. A wick douse pump results in an engine that repeatedly overheats and a machine that Often runs ardent. Replacing the deficient aqua pump helps lock up you don't crack your engine tendency or posses expanded austere engine problems.Reattach the negative battery cable and tighten the screw. Start the vehicle. let it warm up and check to make sure there aren't any leaks coming from the new water pump.
