A drive shaft is used in rear revolve handle vehicles as a income of transferring influence from the engine and transmission to the rear axle differential. The coerce shaft is a hollow metal tube that has usual joints (or U-joints) attached at Everyone location. The U-joints compensate for the rotating progress of propel shaft, besides as the up and down moving of the rear axle as it is negotiating bumps in the method. U-joints get Stirring parts that Testament wear, necessitating their periodic replacement.
Instructions
1. Uplift the rear of the vehicle with a floor jack. Habitat jack stands under Everyone side of the rear axle. Accommodation the drive shaft on a functioning bench or other suitable business globe. Remove the snap call clips from the bearing caps on the accepted Seam you preference to convert, using a twosome of snap ring pliers. Discard the geriatric clips--a replacement accepted Seam comes with dissimilar hardware.
Lower the rear of the impel shaft to the ground. Slide the manage shaft to the rear of the vehicle until it clears the transmission tail shaft. Lower the front limitation of the coerce shaft to the ground and remove it from under the vehicle.
3. Lower the floor jack.2. Crawl under the rear of the vehicle and remove the nuts on the rear manage shaft clamps with a socket and ratchet. Clasp the operate shaft up with one participation while sliding the clamps gone of their mounting holes.
4. Habitat the abyss of a regular Seam Emigration part over the bearing caps of the joint where it attaches to the drive shaft. Turn the handle of the tool in a clockwise direction until the universal joint has been pressed from the drive shaft. Remove the tool.
5. Place a new universal joint in between the mounting holes on the end of the drive shaft. Place the jaws of the removal tool over the bearing caps of the U-joint and turn the handle in a clockwise direction until it is fully seated into the drive shaft. Remove the tool. Insert new snap ring clips over the bearing caps using a pair of snap ring pliers.
6. Repeat the above two steps to replace the universal joint at the other end of the drive shaft, if necessary.
7. Place the drive shaft under the vehicle.
8. Crawl under the vehicle. Raise the front of the drive shaft and insert it into the transmission tail shaft. Raise the rear of the drive shaft and hold it into position with one hand. Insert the bearing cap clamps back into their mounting holes. Thread the nuts back onto the ends of the clamps and tighten them with a socket and ratchet. Wipe up any transmission fluid that may have leaked out of the tail shaft. Remove the jack stands and lower the vehicle.
