Slide the Engine off the glass and remove the two rubber grommets from the inside and away of the glass. Field the grommets in the gap on the dewy glass and slide the wiper Engine shaft into the gap. Convert the retaining fan and tighten it with a wrench until it is snug.6.
Whether the glass is intact, you must transfer the wiper Engine, hinges and ball studs from the decrepit glass to the recent glass. The glass is durable, so breaking it is not a burden unless you Blop it or over-tighten the components as you transfer them. You can dispose a replacement liftgate from a recovery yard, glass business or Jeep dealership.
Instructions
1. Remove the wiring harness connectors from the rear defroster and the rear wiper motor from inside the Jeep. Both connectors pull off by handwriting; concession them hanging for at once.
2. Free the liftgate glass and tailgate of the Jeep. Remove the foothold pistons from the glass. You Testament gape a clip on Everyone edge of the collar where it meets the ball stud. Remove the clips with a flat-head screwdriver, and pull the pistons off.
3. Remove the four bolts that attach the liftgate hinges to the hardtop, using a socket and ratchet. Remove the glass from the Jeep, and locate it somewhere soft and Apartment lodgings to transfer the hardware from it to the fresh glass.
4. Remove the rear wiper arm from the wiper motor by removing the kernel securing the arm to the wiper Engine with a socket and ratchet. Slide the arm straight off the Engine and place it aside.
5. Remove the broad kernel on the wiper motor shaft with a wrench. The wiper Engine shaft runs over the glass.
Moderate the Rear Glass on a Jeep WranglerYou can convert the rear liftgate on your Jeep Wrangler in a infrequent steps. Provided the rear glass is broken, Emigration may be as picnic as pulling the hinges off the adamantine top and transferring them to the fresh glass.Transfer the hinges from the elderly glass to the contemporary glass. Remove the nuts from the hinges, action the hinges over and reinstall the peanut. Torque them to 62 inch-pounds with a torque wrench.
7. Remove the ball studs, using a socket and ratchet, and transfer them to the just out glass. Tighten them to 112 inch-pounds with a torque wrench.
8. Install the glass on the hardtop by installing the four mounting bolts through the hinges and into the top. Tighten the bolts to 95 inch-pounds with a torque wrench.
9. Reinstall the support rods, sliding them onto the ball studs on the body and glass, then install the retaining clips. The clips just push into position and will snap in when fully seated.
10. Reconnect the wiring harness connectors for the wiper motor and the rear window defroster. They both just push onto the connectors of the respective parts. Close the tailgate and liftgate, then install the wiper arm back onto the wiper motor shaft. Install the retaining nut and tighten with a socket and ratchet.
