Bumper covers are the thick plastic covers that most mortals remit to as the bumper of a vehicle. Bumper covers catch a quota of abuse through of their placement on a automobile. From pulling up very lasting to a wall or vitality rear-ended in traffic, bumper covers can easily mature damaged. On account of the covers are normally painted to match the vehicle, repairing them involves repairing the damage and having them painted.
Instructions
1. Sand the damaged universe with 120 grit sandpaper to remove and smooth the surface in and enclosing the damage. Advantage a plastic squeegee to employ a thick layer of Supple protest filler over the damaged field. Provided there is a dent, fill the dent with the filler so that the filler covers the dent and surrounding edges. For holes or tears, cook up positive the filler goes into the crack and earth surrounding it. Avow the filler to dry for one time.
For dents, sand the full dent, inside and all over the edges. For punctures or tears in the bumper subsume, sand along the edges of and enclosing the ripped world. Not all of the dye has to be removed, decent most of it.2.
3. Sand the filler smooth with 120 grit sandpaper. Sand until the filler is all the more with the surrounding surface of the bumper involve and does not sit higher than the surrounding environment. Sand again with 220 grit sandpaper to smooth gone the Rugged surface left by the 120 grit sandpaper. Sponge the globe down with enlarge and grease remover and a rag. District masking tape and paper encompassing the universe so the bumper cover isn't covered in overspray from the primer and distemper.
4. Spray the repaired area with one moderate coat of primer. Hold the can 6 to 8 inches from the surface and use left to right strokes, not up and down. Wait 30 minutes for the primer to dry and then sand it smooth with the 220 grit sandpaper. Wipe the repaired area down with wax and grease remover and allow a few minutes for it to evaporate.
5. Coat the area with three to four thin coats of paint. Hold the can 6 to 8 inches away from the surface and use left to right strokes. Wait 10 minutes between coats. Spray three to four thin coats of clear coat paint on the area, using the same techniques as with the color paint. Pull the masking paper and tape off before the clear coat dries so it isn't stuck to the bumper cover. Wait a full day before handling the area.
