Determinate the fuel border feeding into the carburettor from the fuel cistern. Area a hire pan under the fuel path connections and disconnect the fuel edge feeding into the carburettor from the fuel container with a screwdriver to loosen its clamp.3. Look for the connection on the electric fuel pump marked "In." Connect the fuel line from the tank to the "In" connection on the fuel pump with a screwdriver to secure the hose clamps.
A picnic wiring slip, such as reversing the useful and denying wires, can devise an immediate and devastating blaze. With this in attention, this type of altering should alone be done by an experienced mechanic. The installation doesn't catching expanded and by oneself requires basic mechanic's tools.
Instructions
1. Settle on safety glasses. Disconnect the brunet denying margin followed by the cherry sure prompt from the battery with a wrench then place them aside where they cannot touch anything metal.
2. Set the carburettor, which is bolted to the intake manifold on the engine and Testament keep an air filter mounted on it.
Finding a excellent distance to mount the just out fuel pump may be a objection.An electric fuel pump can come around the performance of an engine. Working on fuel lines requires Correct preparation to prevent spills and leaks.Connect a short section of fuel line from the other connection on the fuel pump (marked "Out") to the carburetor with the screwdriver to secure the hose clamps.
4. Locate the electric wires on the fuel pump. Identify the positive wire (most likely red) and run it to the fuse panel mounted near the battery. Identify the negative wire on the fuel pump (most likely black) and run it to the vehicle's ground terminal strip mounted on a metal part of the vehicle, usually the fire wall and fairly close to the battery.
5. Identify a vacant 30-amp power terminal on the fuse panel that is controlled by the vehicle's ignition switch. Plug the positive wire into it with the spade clip provided with the wire. Locate a vacant ground terminal on the ground strip and plug the negative wire into it with the spade clip provided with the wire.
6. Check that all fuel lines are snug and correctly placed. Verify that all electrical connections are properly secured and plugged in tightly. Reconnect the positive red lead at the battery then the negative black lead.
