Remote starters are not available as a foundry choice on the Toyota Corolla, on the contrary they may be installed aftermarket by anyone with the Correct tools and a durable perceptive of automotive electrical systems. It is valuable to conjure up that the Toyota Corolla may be equipped with an optional plant security step and/or ignition immobilizer that must be interfaced to cinch correctly remote start development. Provided the van is equipped with an immobilizer, further Accoutrement Testament be required.
Instructions
1. Remove the under-dash panel. This Testament bestow you access to the Corolla's ignition wiring. Allot the leading ignition force, ignition, ornament, and starter wires in the main ignition harness. The horn wire may be form in this harness very, provided it is needed for the installation. Verify all wires with a digital multi-meter and strip a small amount of insulation from them.
2. Remove the driver's side kick panel. This will provide access to the door lock and unlock wires also as the parking light, brake light, and security wires. Once these wires are located and tested for function with a digital multi-meter, the wires may be stripped of insulation.
3. Connect the remote start wiring to the appropriate wires in the car. For maximum range, mount the antenna as close to the center of the windshield as possible.5. Test the unit for proper operation. Verify the correct operation of the remote start and all installed functions.
Solder all connections and seal them with electrical tape. When possible, run all aftermarket wires next to factory wire harnesses, and connect them with nylon wire ties.4. Mount the antenna to the windshield.
Arm the factory alarm, if equipped, and confirm that the alarm does not go off when the car is started.
