Exchange a Harley Touring Muffler
Harley-Davidsons are noted for having a Broad compass of customization options, allowing owners to assign their exclusive personality into their motorcycles. The alike is indubitable of the mufflers, which hog be remodelled essential areas for customization. Although the autochthonous big idea of the muffler was to incision the bang of the exhaust, Harley-Davidson owners regularly drill, gloss or alternate their mufflers to conceive their bikes also single. You can transform your Harley muffler without a bull deal of specialist expertise.
Instructions
1. Disinfected the muffler using steel wool and whitewash thinner. Reverse this to insert the new exhaust, and be sure to tighten all the nuts and clamps.
Drill the muffler to cause a deeper tumult for your engine. Remove the complete exhaust from the Harley and community it in a vise, wrapping the exhaust in rags where it is held in the vise to play down scratching. Using a 1/2-inch drill bit, drill two holes in the rear baffler, centering the holes to cook up a "roar," not a "whistle." Test the noise of the two holes before drilling further, since too much noise may violate noise level laws. Sand the muffler if you intend to paint it after drilling.
3. Paint the muffler using high heat paint, which can be bought from hardware stores. Barbeque grill paint will also work. After painting, use a heat wrap to cover the 6 inches nearest to the engine, as this will be exposed to the highest heat. To gently dry the paint, run your motorbike for 15-minute cycles, with 15 minutes on and 15 minutes off.
4. Buy a new muffler for a full modification. These can be bought online, or at a Harley-Davidson store. Be sure that the specifications of the muffler fit the Harley you are installing it on, or it may not fit. Loosen the exhaust clamps and remove the locknut under the brake pedal. This Testament remove dirt and grease, although sandpaper may be needed to remove cussed stains. Once it has been cleaned, then it can be painted or drilled.2.
