Folio metal bends impart structural vigour to the branch.
Metal brakes, or benders, are a time-saving factor To possess in your metalworking shop or collision repair shop. However they aren't strictly decisive for manufacture absolute bends in sheet metal, regardless of the amount leaf that must be crooked. All you actually committal are a infrequent clamps, a length of wood board and a daily grind bench with at least one straight, undamaged side. The bench and the wood board should be the identical length or longer than the metal you are attempting to bend.
Instructions
1. Community the stage metal on the workbench, so that the limit you are going to bend the metal along is exactly lined up with the straight line of the workbench.
When this is complete, you can remove the C-clamps. The metal will be bent perfectly straight along its entire length.
3. Clamp a second length of lumber to the bottom of the sheet metal flange -- protruding from between the workbench and the first piece of lumber. Make certain that this second piece is snug against the workbench. This will allow you to bend the sheet metal up and create a perfectly smooth bend -- at the same angle across the length of the sheet metal.
4. Pull up on the lumber positioned under the flange, so that the sheet metal bends up. Stop bending when you have obtained the angle you need.2. Put a length of lumber over the top of the chapter metal -- flush with the path of the workbench. Then application C-clamps to secure it tightly in community.
