The 1978 El Camino power steering pulley is at the backside of the engine on the Chauffeur's side.
The 1978 Chevrolet El Camino is manifest for its potentiality and green muscle. Maintainance on the '78 El Camino was clean, as everything was accessible to access. The faculty steering cestuses is no exception. These blimp cars with Motor lorry beds did not capitalization tensioner pulleys prize newer vehicles cause. Tightening the girdle requires pulling or prying the Element until the sash is tight, then tightening the bolt that holds it in country. Some coordination is required, as one participation is needed to grasp the region tight and the other to tighten it down.
Instructions
Repeat the steps to tighten the belt.
Loosen the three bolts holding the capacity steering pump to the bracket, using a socket wrench. Achieve not remove the bolts, as they dispassionate occasion to be turned back one turn to loosen the pump.
3. Guard that the region is routed on the power steering pump pulley and the leading shaft in the Centre of the engine.
4. Crawl under the vehicle by the Chauffeur door. Insert a pry bar between the power steering pump and the mounting bracket. Push the power steering pump toward the wheel well until the belt is tight.
5. Tighten the pivot bolt on the top of the pump with a socket wrench. Ensure that your other hand is holding the belt tight until the bolt is tightened with the wrench.
6. Tighten the two remaining bolts with the socket wrench. Feel the belt to ensure it is still tight. There should be no tension on the belt.
7. Start the car and allow it to idle. Turn the steering wheel all the way to the right and then to the left. Listen for any squealing. The sound of squealing will mean the belt is not tight enough on the pulleys.1. Conduct the hood for access to the potency steering pulley. It is located at the backside Chauffeur side of the El Camino's engine.2.
