Silver a Starter Solenoid in a '95 Nissan Sentra
Whether your 1995 Nissan Sentra doesn't inauguration when you turn the chief, there a infrequent matters that could be the rationale. Most transparent is a dead battery or a defective starter, on the other hand the starter solenoid could be the dilemma also. Starter solenoids bring about a clicking sound when the ignition main is turned, and the sound is heard as extensive as the battery is charged. Provided the battery has a skilled charge and the connections on the battery cable are acceptable, nevertheless no clicking sound is heard when you turn the explanation, the starter solenoid is the complication.
Instructions
1. Field the vehicle on a constant surface. Operate the emergency brake. Assign bricks or blocks endure the back tires to deposit the vehicle from rolling once the vehicle is on jack stands.
2. Disconnect the negative cable from the battery.
3. Place the jack under the vehicle and raise the vehicle. Raise the vehicle high enough to allow room to work under the vehicle.
4. Place jack stands under the frame on both sides of the car. Lower the jack slowly until the vehicle is supported by the jack stands.
5. Disconnect the battery cable and solenoid connector from the starter using a socket and ratchet.
6. Remove the mounting bolts from the starter using a ratchet and socket. Remove the starter from the engine. The starter solenoid is mounted on the end of the starter by bolts that are only accessible once the starter is removed.
7. Remove the nut that connects the solenoid wire to the starter. Remove the wire.
8. Remove the retaining bolts that secure the solenoid to the starter. Separate the solenoid from the starter.
9. Install the new solenoid on the starter. Reattach the retaining bolts.
10. Connect the wire from the solenoid to the starter. Secure the wire with the nut that was removed previously.
11. Place the starter back in position. Line up the holes for the retaining bolts. Install the retaining bolts and tighten.
12. Connect the battery cable and solenoid connector to the starter.
14. Connect the negative battery cable.
13. Place the jack under the car. Raise the car high enough to remove the jack stands. Slowly lower the car back to the ground.
