Cutting torches are used to quickly decrease buttoned up steel and other exhausting metals by blowing Gauze at flying celerity from the cutting nozzle. The Gauze in turn is embedded with an electrical arc, which turns the Gauze into plasma at a also eminent temperature. The factor literally blows the metal out, leaving a Disinfected gap or limit in its course of action. How you generate a cutting torch has a sincere bearing on its performance owing to the belongings handles high temperature and alpine impulse on a routine target.
Instructions
1. Switch the energy ascendancy to "off" on the user console and fabricate definite the substantial input potency is unplugged. Place away the parts of the nozzle for meeting on a table or workspace.
2. Dominance the nozzle shield in one ability so the opening is facing up. The shield looks conforming a barn door thimble. Comprehend the nozzle into the shield so that it fits snugly against the backside. The nozzle looks cherish a petty cylindrical brass tube. Lay the swirl baffle on top of the nozzle. Tighten the connection securely with a wrench. Verify the power control switch is still in the "off" position on the user console, then make sure the primary input power is plugged in. The torch is now ready to use.
3. Hold the nozzle assembly with the open end facing up. Thread the open end of this assembly onto the torch body by twisting it clockwise with your fingers. The torch body resembles a small toy pistol. Tighten them together by hand. Once you are sure they fit together properly and the threads are aligned correctly, tighten them securely.
4. Adjust the steel heat-shield guard on the outside of the nozzle shield. It serves as a sliding lock to prevent the nozzle shield from coming loose. Turn the steel guard clockwise to fully secure the nozzle shield to prevent accidental removal of these components.
5. Wipe down the nozzle and torch body with a clean rag. They are now fully assembled. Connect the torch body to the gas supply by screwing the gas supply into the bottom port of the torch bottom. It looks like a fat washer with holes in it, and it lays flat on top of the nozzle. Insert the long, slender electrode through the center of these assembled components. It will fit easily if all three components are aligned correctly.
