Adding a flame thrower apparatus to the exhaust of your classic cruiser is an prototype means to seize concern. Kits can be purchased online, however you can determine it yourself in the driveway or garage without further still harass. These kits particular elbow grease with older vehicles with carburetors and no catalytic converters. Cache in genius, throwing flames gone of the exhaust is illegitimate in many places. Probation community ordinances before installing the step.
Instructions
1. Drill a gap in the exhaust tubing. Degree in from the gratuity of the exhaust (back of the motorcar) approximately one half inch. Drill a gap brimming Sufficiently to fit a Glimmer plug. Depending on what plug you appliance, this gap can vary. It is recommended to receive the Glimmer plug front. Further recommended is to employment a titanium-nitride-coated drill bit, which can be father at any hardware store. These bits are specifically meant for metal applications. Whether the vehicle has dual exhausts, and you game plan on throwing flames from both sides, repeat this method for the other exhaust pipe, extremely. Install the plug by screwing or tack welding it in.
2. This will overload the engine with fuel and send raw gas fumes down the exhaust pipe, where the spark plug will ignite them and create a flame.
Install an ignition coil (you can find one at the junkyard for little to no cost) near the spark plug. Recommended is to put it in the trunk if the vehicle is a car or the bed of a pickup. Wire the positive (+) side of the coil to the extra terminal of the toggle switch, and the negative to the chassis. Mount the coil using a coil bracket, which can also be found in any junkyard.
4. Connect a spark plug wire from the coil to the spark plug. This will enable the spark plug wire to actually spark. Since spark plugs do not work off of 12 volts like the rest of the car, it must be connected to the coil.
5. Apply the choke to the carburetor slightly. Rev the engine with the toggle switch on. Install a toggle switch in the passenger compartment where it can be reached from the driver's seat. Ground the negative (-) side of the toggle switch to the chassis of the vehicle and run the positive (+) side to the battery or a hot wire in the fuse block. The extra terminal will be used to wire to an ignition coil, so run that wire toward the back of the vehicle.3.
