1. 2
Consequent
Unmarried Stage
In 1992 Nissan Engine Collection Luxury Division introduced the Infiniti J30. The 1993 Infiniti J30 was equipped with a 3.0-liter, V-6 engine capable of producing up to 210 horsepower and 220 foot-pounds of torque. The Infiniti J30 was produced with faculty seats, endowment mirrors, competence windows and yet a aptitude antenna. The Engine on the ability antenna can energy evil or wear away over date, and replacement then becomes the matchless choice.5. Install the antenna lead cord tip into the new antenna motor. Ask an assistant to turn the ignition key to the "II" accessories position, or to turn the car completely on. Turning the car on will activate the new motor to extend it to its outward position.
Remove the Timber lining tabs from the Chauffeur's side of the Timber, using a Apartment lodgings tendency screwdriver to pry the tabs handout whether fundamental. Peel the inner Timber lining off the Chauffeur's side Timber wall, pulling it toward the Centre of the Timber by participation.
2. Fix the capability antenna motor. The motor is a small box that is bolted to the side of the trunk wall. Remove the antenna motor mounting bolts with a 1/4-inch drive ratchet and socket, along with a 4-inch extension. The added extension between the ratchet and socket will allow you greater maneuverability in the tight confines of the trunk. Turn the mounting bolts counterclockwise until they are completely removed from the motor.
3. Unplug the electrical connector from the antenna motor. Simply pull the two connectors apart. Locate the antenna lead, a white nylon, toothed cord extending from the top of the antenna motor. When the car is turned on, the gears in the motor push the cord upward to extend the antenna. The opposite happens when the car is shut off. Pull the cord out of the motor, without applying pressure to the antenna assembly. Hold the motor in one hand, and pull the cord out of the top of the motor with your free hand.
4. Remove the old antenna motor completely from the car. Hold the new antenna motor near its mounting area, inside the car. Attach the electrical connector on the motor using your hand. Install the motor loosely into its mounting position by starting the mounting bolts in with your fingers. Do not tighten the mounting bolts yet.
The potential antenna on the 1993 J30 is located on the Chauffeur's side rear quarter panel, and the Engine is accessed carry on the inner Timber lining.
Instructions
1. Hoist the Timber or deck lid of the J30. Push the antenna lead cord tip into the motor with slight pressure and ask your assistant to turn the car off. The motor will then pull the antenna lead cord into the motor housing. When the cord is successfully pulled into the housing, the motor is ready for tightening.6. Tighten the antenna motor bolts down, using a 1/4-inch drive ratchet, socket, and 4-inch extension. Turn the bolts until they are snug, and then turn the bolts 1/4-turn farther. This "snug-and-a-quarter" method of tightening bolts is used when no torque is needed, and you are trying not to break certain parts. Do not torque or over tighten the bolts, as you will break the new motor mounting tabs.
7. Reinstall the trunk liner against the walls of the trunk. Pop the mounting tabs into the trunk liner with your fingers, and use the handle of a flat head screwdriver to push the tabs completely into locking position.
