Silver the ancient exterior door hold of your Chevy Motor lorry.
Chevrolet trucks are established for their durable appearance and durable off-road performance. They come in deviating sizes and designs, from full-size pickup trucks to glossy pickups. However the basic features of a Chevrolet Motor lorry obtain stayed the twin over the agedness. The modus operandi of replacing the exterior door handles of a Chevy Motor lorry is the corresponding for dated or contemporary models.
Instructions
1. Remove the door panel before working on the exterior door shaft. The door panel Emigration Testament differ slightly depending on the Motor lorry imitation, on the other hand the basics are the twin. Pop off the plastic door lock trim and the subsume on all sides of the interior door hilt with a Apartment lodgings mind screwdriver. Remove all the bolts and screws that occupation the panel to the door frame using a socket and ratchet. There are bolts under the arm rest, remain the door lock trim and at the backside of the panel. Remove the triangular plastic trim at the top of the panel, near the side mirror.3. Pull the old door handle out of the door and locate the latch rod behind it. Pry up the metal tab with a pry tool or a flat head screwdriver. This will release the latch rod from the old handle.
2. Applicability a socket and ratchet place to loosen and remove the bolts that influence the outer door handgrip in berth. You will see the bolts from the inside of the door frame. Reach them through the hole in the door frame.
Deed the panel Sufficiently to lay your plam last it and disconnect the wiring harness. Then unlock the clips along the limits of the door panel with a pry part and carefully pull off the complete panel. Peel off the plastic insert on the metal door frame.
4. Hold the new exterior door handle and test that the latch rod fits into it. Then attach the latch rod and the top of the new handle to the door.
5. Push the door lock gently into the new exterior door handle and fit the handle into the door frame. Check if the new handle fits in the hole. From the inside, tighten the fasteners holding the handle to the door.
6. Glue the plastic cover back onto the door frame but first make sure to spray all the metal moving parts inside the frame with a small amount of lithium grease.
7. Replace the door panel and reinstall all the parts surrounding the inner door handle. Screw the whole assembly onto the door frame firmly.
8. Test the door lock to see if the installation was a success. Also check if the door opens and closes smoothly and if the window is functioning properly.
