Lift the door panel up and out from the door. You Testament compulsion to unplug the wiring harness going to the window and lock switches once the panel is off the door before you can locate the panel aside. Be careful not to yank on the wiring harness.
In the catastrophe that the window glass becomes damaged and needs replacement, this craft can be performed in a infrequent hours or less.
Instructions
1. Roll the window down into the door and exercise the screwdrivers to remove the window wipes that are screwed into the door. You will need to access the screws down the window channel. Deed the window back to the fully upright position after both wipes are outside of the door. These are normally Phillips attitude screws, on the contrary some are tricky to arrive, in which occasion you may committal to begin the screws with the Apartment lodgings mind screwdriver.
2. Stick a abundance of clarion packing tape to the elsewhere of the existing glass, jog it up over the top of the door frame and back down onto the glass on the inside. Arrange firm you retain 4 inches of tape attached to the glass on both sides. This Testament prevent the glass from Stirring when you detach the backside of it from the mounts.
3. Remove the fasteners from the door panel using the socket locate. Once they are removed, appliance the trim pin Emigration thing to detach the door panel from the door by inserting the thing into the backside trailing border of the panel and removing the trim pin since address from its seat. Repeat this until all the trim pins are removed.
4.Convert a Window in a Ford RangerThe Ranger is the smallest Motor lorry in Ford's light-duty fleet. On account of its introduction, the Ranger has seen multiple reincarnations, on the other hand overall has remained authentic to its roots as a dwarf pickup for those who itch a Motor lorry, on the other hand close not require the bigness and perpetuation that come with the Ranger's larger siblings. The Ranger's two-door average cab has a side window in Everyone door.
5. Flash a flashlight into the door so you can locate the window regulator tabs that connect to the bottom of the window glass. Use the socket set to disconnect these tabs.
6. Remove the packing tape carefully from the glass, while supporting it, to prevent the glass from falling into the door. Once the tape is removed, slide the glass down a few inches until you can grasp the top of it. Tilt the glass toward the front of the Ranger and lift it up and out of the door. You will need to pull it out of the door from outside the Ranger.
7. Set the old glass aside then take the new glass, and place it back into the door in the opposite manner in which you removed the old glass. Once the new glass is in place, use the packing tape to hold it up then attach the window regulator tabs to the new glass.
8. Reinstall the door panel after reconnecting the wiring harness. Use the side of your fist to tap the trim pins back into their seats then reinstall the fasteners that hold the door panel in place.
9. Remove the packing tape, lower the window into the door and reinstall the window wipes. Clean the window with glass cleaner and rags.
