Moderate the Brake Pads on a Silverado
Hard by to performing oil changes, replacing brake pads is one of the simpler do-it-yourself projects a vehicle owner can undertake. While there are no speciality tools required, you Testament commitment a basic stuff fix, a worthy jack and jack stands, some usual impression and elbow grease. The chore can be fatal, so accomplish firm To possess a fair grind amplitude and avoid distractions. Most brake jobs can be done Homewards in a rare hours or less.
Instructions
1. Locate the parking brake and chock the rear wheels to prevent the Motor lorry from rolling.
2. Situate on your safety glasses and employment the lug wrench to loosen the front lug nuts so that you can remove them by handwriting consequent.
3. Field the jack under the frame in the honest front earth and carefully uplift the Motor lorry. Build certain the jack is contacting the frame and insignificancy else so you end not accidentally damage the Motor lorry.
4. City a jack stand under the frame hard by to your jack objective and then carefully lower the jack until the Motor lorry is resting firmly on the stand.
5. Remove the front wheels and set them off to the side.7. Put a drain pan under the brake assembly and spray it off with brake cleaner. Brake dust is hazardous to your lungs so you want to receive as much off the brakes as possible.
Repeat Steps 3 and 4 on the front left side. You should at once include the filled front of the Motor lorry raised off the ground and resting securely on the jack stands.6. Select the front lug nuts off and locate them someplace secure so they end not arouse lost.
8. Use the socket wrench and corresponding socket to remove the brake caliper bolts. Then slide the brake caliper outward off the brake rotor. At this point, it is recommended that you replace the brake rotors or remove them and have them machined. In the event you cannot do this, you should scuff the surface with sandpaper in a circular pattern to remove the sheen built up from braking. If there are any grooves in the rotor or a lip at the outer edge, it should be replaced. Always replace rotors in pairs.
9. Slide the old pads out of the brake caliper and slide the new ones back in. At this stage you will also want To cleanse and lube the caliper slide pins using brake cleaner and white lithium grease.
10. Reinstall the caliper in the opposite manner in which you removed it and bolt it back in place.
11. Repeat Steps 7 through 10 on the other side.
12. Put the wheels back on and hand tighten the lug nuts, then lower the vehicle back to the ground in the opposite manner in which you raised it.
13. Use the lug wrench to firmly tighten the lug nuts. If at all possible, it is best to use a torque wrench and torque the lug nuts to 100 foot-pounds. Do not over-tighten the lug nuts as this can cause the rotors to warp. If you do not own a torque wrench, tighten them as best as possible then swing by a tire shop or service station To possess the lug nuts torqued properly.
