4. Remove the power steering reservoir cap again and check that the fluid level is at the "H" mark on the dipstick of a 3.4-liter engine, and at the "Hot" mark in the 3.8-liter engine. If not, add GM power steering fluid -- GM part No. 1052884 -- or equivalent.5. The 2003 Impala came in two trim levels, mould and LS. The representation mould had a 180-horsepower, 3.4-liter V-6 and the LS came with a 200-horsepower, 3.8-liter V-6. Both trim levels came guideline with bent steering and checking the bent steering fluid is an earnest prolongation employment that every Impala owner should apprehend determine.
Instructions
1. Inauguration the engine and own it to arrive operating temperature -- roughly partly up the Impala's temperature gauge. Shut the engine down and unlocked the vehicle's hood To admit the engine compartment to refreshing, nevertheless not the engine itself.
2. Bonanza the power steering reservoir -- the dingy plastic cistern -- on the top-passenger's side of the 3.4-liter engine and under the alternator on the 3.8-liter engine.
3. Remove the endowment steering reservoir cap by turning it counterclockwise and pulling it from the reservoir -- consideration the dipstick attached to the cap. Wipe the dipstick off with a clean, lint-free cloth and set the cap back on the power steering reservoir. Tighten the power steering reservoir cap.
Chevrolet launched the full-sized Impala in the 1958 example year, and it experienced almost prompt boom. In 1985, Chevrolet eliminated the Impala from its lineup, on the other hand the nameplate returned from 1994 to 1996 as the Impala SS. In 1999, Chevy reintroduced the Impala as its own replica, on the other hand as a mid-sized front-driven sedan.
Recheck the power steering fluid, following Steps 3 and 4. Reinstall and tighten the power steering cap once the fluid reaches the correct level.
6. Close the Impala's hood.