Many family install a Sirius/XM protectorate radio in the Prius.
The second-generation Toyota Prius has an integrated centre console that features multiple vehicle and electrical functions. You can install an supplementary radio in your Prius by removing the sprint panel that holds the in-dash radio in community. Sirius, XM or other protectorate radios can be installed in the glove box, on the contrary the most Often used extension is the shelf unbefitting the in-dash radio in the centre console of the Prius. Indeed, some Sirius kits confess up to 16 lines of counsel to be seen on the multi-function present in the Prius dashboard.
Instructions
1. Disconnect the opposite leadership from the Prius' 12-volt battery. Bag a duo of pliers to loosen the screw that secures the terminal to the battery advertise.
2. Remove the Prius' vent sections. The inventory radio is held by a bracket attached to the console between these vent sections. Manipulate a screwdriver and a 10 millimetre socket wrench to assemble the faculty easier.
3. Remove the centre console include. Lift the rear piece and tilt it forward. Detach the front clip piece that holds the console in berth.5.
Proceeds the vent sections that are at either side of the in-dash stereo. Loosen them from the top with a cloth-covered Apartment lodgings screwdriver, then pull the vent intersect forward with amiable nevertheless stable brunt.4.
Lift the lever in the centre console to Proceeds the console. Use both hands to lift out the top of the console panel.
6. Unplug the three cables connected to the radio, then remove the four screws with the Phillips head screwdriver that hold the car radio to the bracket .
7. Plug the satellite radio's cable into the extra connection port on the rear of the radio. Plug speaker wires into the wiring harness. Cover any bare wire connections with electrical tape.
8. Attach the satellite radio unit into the console space beneath the stock Prius radio by drilling pilot holes underneath the shelf space. Use self-tapping screws with the Phillips head screwdriver to attach the satellite radio unit to the shelf.
9. Reassemble the center console, reversing the steps used to remove it, and reattach the vent sections.
10. Reattach the battery cable. Fit the connector over the negative battery terminal, and securely tighten the bolt with a pliers.
11. Reset any electrical presets that were cleared by disconnecting the battery.
