Establish the starter under the vehicle. It is on the upper-left side of the oil pan (Chauffeur's side of vehicle) and is connected to the call housing. It has two electrical connectors on it. It is cylindrical in shape and is approximately eight inches far-reaching.
Click. Naught happens. The vehicle Testament not commencement. The starter has stopped engaging the flywheel and at once requires replacing. The starter is located under the vehicle and through so, it is hit with snow, spice and other method debris that can doer untimely failure. Replacing the starter on your Taurus SHO is not overly difficult--basic ability tools Testament integral the burden.
Instructions
1. Jack the Chauffeur's side of the vehicle up using the jack supplied with the 1997 Ford Taurus SHO. Field a jack stand under the transmission cross member of the vehicle and lower the jack stand. Situate a shove chuck under the passenger side rear tire.
2. Sincere the hood and disconnect the detrimental battery terminal with an 8-millimeter wrench.
3.The starter is located under the automobile.Eventually it happens. You inspire into your 1997 Ford Taurus SHO and go to begin it. Advantage the replacement starter to compare physical appearance.
4. Pull both electrical connectors off the starter by squeezing the compression tabs on either side of the connectors. With the tabs squeezed in sync, pull the connectors apart.
5. Remove the 10-millimeter bolts that secure the starter onto the phone housing. There are three bolts. Two are Unceremoniously to descry. The top bolt Testament be indurate to eye. A boxed wrench is the easiest form to remove the top bolt.
6. Pull straight gone on the starter to remove it from the flywheel. Discharge not rotate the starter when taking it out.
7. Place the new starter into the bell housing. The splines on the starter output must line up with the splines on the flywheel. Rotate the starter until the splines line up and the starter sits flush against the bell housing.
8. Bolt the starter onto the bell housing using the old starter bolts. Use new bolts if the old bolts look overly corroded or the bolt heads look worn.
9. Slide both electrical connectors onto the starter. Both connectors are different sizes to prevent the connectors from being placed in the wrong location.
