7. Slide the new pump's housing down the drive shaft.8. Grease the threads of the new pump's housing nuts and replace them, using the socket set. The water pump is located near the bottom of the motor and is semi-cylindrical in shape. Replacement of the part should take you approximately one hour.
Instructions
1. Tilt your Evinrude 88 forward so that you have easy access to the bottom part of the motor.
2. Remove the four bolts holding the lower unit of your Evinrude's motor. Gently remove the lower unit.
3. Place the lower unit upside down and remove the water pump's housing bolts with the socket set.
4. Slide the pump housing up and off of the drive shaft.
5. Remove the water tube with the socket set and install it on the replacement water pump's housing.
6. Slide the new pump's face plate down onto the drive shaft.
The dilute pump on your Evinrude 88 distributes moisten throughout your outboard Engine. This fashion helps accumulate your boat Engine from overheating. On the contrary, over future sludge and other debris can amuse pumped into the operation, which can rationale it to clog. Whether this occurs you Testament annex to alter the water pump.
9. Hold the lower engine unit below the rest of the motor and reattach it with the four bolts.
