Replacing discoloured or worn seat belts can dramatically develop the appearance of the Mustang's interior.
The 1965 Mustang was equipped with lone a ambit girdle as the shoulder cummerbund was not used in the Mustang until 1968. The ambit girth consisted of two halves that fastened stable. The belts were usually coloured to match the interior of the van. Over date, the colour tends to fade. Deeper recurrently than not, but, the information hardens over duration, creation it galling to appropriateness and dolorous to wear. Happily, replacing the front seat belts in a 1965 Mustang takes one a infrequent minutes.
Instructions
1. Stretch underneath the seat to access the seat's reconciliation handle, then lift up on the handle and slide the seat to its extreme forward position.
2. Remove the single bolt from the base of each half of the seat belt attached to the floor with a wrench.
3. Lift both sides of the seat belt out of the vehicle. Take care not to lose the two washers on each side.
4. Apply weatherproofing sealer around the hole in the floorboard where the seat belt's retaining bolts enter.
5. Press one washer onto the sealer, ensuring that the hole in the center of the washer aligns with the hole in the floorboard.
Slide one washer onto each seat belt retaining bolt.8. Insert the seat belt's securing bolt into the hole in the floorboard then tighten the two securing bolts with a wrench.
6. Position the bracket which secures the seat belt over the washer, ensuring that the hole in the bracket aligns with the hole in the washer.7.
