Transform a Fuel Pump in a Ford Taurus Estate car
The fuel pump in a Ford Taurus estate car moves the petrol from the fuel tank forward to the fuel injection manner. The pump is located inside the fuel vat and relies on the petrol itself to lubricate and arctic it. Continuous driving with low fuel puts undue strain on the fuel pump and can edge to a untimely demise. Whether your fuel pump fails and you corner basic auto-repair skills, a unharmed calm environment to office and an age of Leisure time, you can change the fuel pump in your Ford Taurus estate car.
Instructions
1. Govern the Taurus's hood and disconnect the bad battery cable from the battery with the battery wrench. Shove the spin chocks against the right-front turn to prevent the Taurus from rolling.
2. Lift the rear of the Taurus with the floor jack. City the jack stands under the jack points on the oppose rails. Lower the Taurus onto the jack stands.
3. Reposition the floor jack underneath the Taurus's fuel vat. Hoist the jack imagination so it rests against the backside of the vat. Place the screwdriver against the lip of the fuel pump retaining ring and tap the screwdriver handle with the rubber mallet to turn the ring counterclockwise.6. Remove the retaining ring by hand.
5. Lift the container off the floor jack and set it on a clean, level surface. Wrap the rag around the tip of the screwdriver. Unbolt the vehicle retaining straps with the socket fix.4. Lower the fuel container assorted inches until you can distance up and disconnect the fuel lines and wiring harness from the fuel pump by handwriting. Lower the vat remainder of the habit and pull it outside from under the Taurus on the floor jack.
Pull the old fuel pump out of the Taurus's fuel tank by hand, noting its position and orientation in the tank. Insert the new fuel pump, making sure to align it just as the old pump lined up prior to removal.
7. Tighten the fuel pump retaining ring onto the tank in reverse of removal. Move the fuel tank back onto the floor jack. Roll the jack and tank back under the Taurus.
8. Lift the tank with the floor jack until you can reconnect the fuel lines and wiring harness to the fuel pump. Lift the tank the rest of the way with the floor jack. Reinstall the tank retaining straps in reverse of removal.
9. Lower the Taurus off the jack stands with the floor jack. Reconnect the negative battery cable to the battery with the battery wrench.
10. Prime the fuel system by turning the ignition to the run position for ten seconds and then shutting it off. Repeat the prime procedure once more before starting the Taurus.
