Dirt and saturate can be concentrated on a motorcar's fuel course.
The Honda Acquiesce is one of the most common vehicles on the path nowadays. Absolutely, Edmunds sites the Coincide as an "automotive statue and one of our editors' top recommendations." By blending performance and reliability, this leading stay has been a Honda staple for over three decades. But, as with any vehicle, after a cipher of agedness the vehicle may generate problems by life exposed to contaminates such as dirt and imbue that can alter the fuel method. These elements can account fuel pump failure. With some basic tools and approximately 1 generation of your age, you can modify your fuel pump later this do-it-yourself instructional.
Instructions
Removal
1. Loosen the colorless battery terminal with a wrench and remove the cable. Compass the cable elsewhere of the occupation earth gone from the battery.
2. Depressurize the fuel process. While the engine is biting, unscrew the fuel filling cap and allot it aside. Field a 6mm wrench at the top of the fuel channel. Cut another wrench and attach it to the banjo bolt. Using the 6mm wrench, turn the bolt one turn. Appliance a rag over the becoming to avoid spray.
3. Position the floor jack and hoist the vehicle. Cover the jack stands and lower the vehicle down onto them.
4. Fix the empty plug on the backside of the fuel vehicle. Bag a wrench to remove it and grant the fuel to bleed into your void pan.
5. Open the trunk and locate the wire harness and connector for the fuel pump. Disconnect them.
6. Locate the fuel line protector and valve cover. Remove these using a wrench. Disconnect all lines and hoses that are attached to the fuel pump. Use wrenches to remove fuel lines.
7. Insert the floor jack underneath the fuel tank and raise it up until it just touches the tank.
8. Disconnect the fuel tank straps by removing the retaining nuts. Perform this with a ratchet and allow the straps to hang down.
9. Lower the floor jack to remove the fuel tank. Locate the nuts that hold the fuel pump in. Remove these with a wrench and pull the fuel pump out of the tank.
Installation
10. Insert the new fuel pump into the tank and take care to ensure that it is completely sealed.
12. Reconnect all fuel lines and wiring harnesses---don't forget the one in the trunk. Some fuel lines require new washers.
11. Raise the fuel tank back into the car using the floor jack. Tighten the fuel tank strap down by tightening the strap nuts. Remove the floor jack. Install these now if necessary.
13. Remove the jack stands by raising the vehicle with the floor jack. Carefully use the floor jack to lower the vehicle.
14. Reattach the negative battery terminal and tighten it down with a wrench. Test the fuel system by adding 3 gallons of gas to the tank and running the engine.
