The Ford Explorer is easily one of the most common SUVs of the 1990s. Built on the duplicate frame as Ford's habitual Ranger trucks, the Explorer borderline is a reliable and sturdy vehicle. Provided you glance at a cracked radiator in your Explorer, you can interchange it yourself and prolong the activity of your automobile.
Remove the fan bolts also as the shroud, followed by the 4 radiator push pins. Too remove the A/C condenser brackets near the rear of the radiator, and wire the A/C condenser in country to deal in it from getting damaged.6. Remove the radiator from the engine compartment.
Unfastened the extract cock on the lower rear of the radiator, remove the radiator cap and extract the coolant into an empty container. Remove the overflow tube from the radiator and the coolant recovery bottle.
2. Unbolt the shroud with a 10 mm socket wrench and position it over the fan, outside of the system. For a 5.0 litre engine on a 1991 completed 2001 Explorer, and disconnect the electric fan wires and remove the radiator shroud. For a 4.6 litre SOHC engine, remove the A/C tubing from the retainer clips on top of the radiator.
3. Utilize a Ford base particular disconnect tool to remove the transmission coolant lines on an automatic transmission. You can employ two crescent wrenches as a substitute for the disconnect tool, condign be careful not to twist the lines.
4. Remove the four bolts holding the radiator in apartment with a 10 mm socket wrench. Assign a quota of cardboard on the side of the radiator facing the engine as you remove it, to prevent damage to any engine components.
5. Crawl under your Explorer and appropriate the cooling fan away for 2002 and newer models. Again, you itch some Ford particular disconnect tools to close this.
Instructions
1. Disconnect the contrary battery terminal to prevent damage to any electrical parts.Models made between 1991 and 2001 will let you lift the radiator out by itself. For a 2002 or newer model, pull the radiator up, rest it on the wall of the engine compartment, and separate the A/C condenser from the radiator.
7. Install the new radiator in the engine compartment. Once you have it resting in place, reattach all components in reverse order. Use a flush treatment, then replace the coolant. Turn the car on and let the car idle, with the heater on and the radiator cap removed, until it reaches normal operating temperature. Top off your coolant as needed.
