The outer pad needs to be installed onto the anchor. Apply a small layer of anti-squeal lubricant to out side of the outer brake pads. Next, install the disc brake caliper onto the anchor plate.
Disconnect the antagonistic battery cable. Using a syringe, turkey baster or complementary stuff, bleed two thirds of the brake fluid from the skillful cylinder. Remove the spin and the tire meeting.
2. Remove the CD brake caliper locating pins and lift the caliper meeting from the rotor and caliper meeting from the anchor plate. Using mechanic's wire suspend the caliper from the frame. Assure that the caliper does not hang from the brake hose. This may damage the hose.
3. Remove the inner and outer brake pads from the caliper. Study the rotor for damage and alter it whether de rigueur. Push the caliper pin back into the Muzzle using a goodly C-clamp and a block of wood. Install the inner and outer brake CD pads and the anti clatter clip. Once the pads gain been installed in the CD brake caliper, install the CD brake caliper and pads.
4. Disinfected any debris or rust from the inside of the caliper in the brake pad contact nature. The inner pad needs to be installed into the caliper piston.Provided your 2001 buttoned up 2004 example Ford Taurus comes to a screeching halt when you block or provided the automobile pulls to one side when you application the brakes, you carry a complication. Another note that you committal to administer concern to your brakes is whether your brake brilliance stays on when you turn on the engine. This can be rectified by replacing the front CD brakes on your Ford Taurus.
Instructions
1.
5. Install the caliper locating pins. Using a torque wrench, torque wrench the caliper locating pins to 23 to 28-ft. lbs. Install the wheel and tire assembly. Place the lug nuts on and using a torque wrench, torque the lug nuts to 85 to 104-ft. lbs.
6. Add brake fluid to the master cylinder. Bleed the brakes. Reconnect the negative battery cable to the battery. Start the engine and pump the brakes 3 to 4 times to seat the brake pads. Test drive the vehicle at slow to moderate speeds to ensure that the maintenance was performed in the correct manner.
