Between 2003 and 2007, the Honda Comply offered a 240 horsepower 3.0L V6 engine with a six-speed instruction or automatic transmission. This seventh siring Assent offers straightforward, dependable transportation and is widely public among used-vehicle shoppers. Removing and installing the exhaust manifold is rather straightforward, very.
Instructions
Remove the Exhaust Manifold
1. Lift the vehicle and build positive it is secure. Loosen the screws and remove the engine undercover. Obtain the exhaust drainpipe with the gasket from the exhaust manifold and place it aside.
2. Lower the vehicle and remove the exhaust manifold heat shield. Loosen the mounting nuts and remove them from the manifold.
3. Lift the manifold from the engine. Remove the broken down gasket and discard it. Scrape any gasket information from the manifold.
Install the Exhaust Manifold
4. Start the engine. Check for exhaust leaks.
Place the gasket in deposit. Install the exhaust manifold. Tighten the nuts in sequence working away from the centre in three passes to 23 foot pounds.
6. Replace the heat shield. Tighten the bolts to 16 foot pounds.
7. Raise the vehicle again. Connect the exhaust pipe to the manifold with the new gasket. Tighten the nuts to 40 foot pounds.
8. Disinfected the gasket mating surfaces with solvent and compressed air. Dry the surface thoroughly then research to generate firm there is no damage.5.
