The brake lines on your Ford F150's brake system can puncture, or alter to damaged or corroded, relevant to a loss of brake fluid. You longing to convert these damaged lines quickly to avoid an bump on vehicle performance. Everyone brake meeting has its own path and hose that connects it to remainder of the step. When you remove and exchange a border, it lets air into the step that you desideratum to bleed gone once the installation is entire. Accumulate in attention that this action requires an assistant.
Instructions
1. Use a prefabricated brake line that is already bent into the shape needed and is flared with the fittings attached at both ends. Tighten the fittings.5.
See the dispute of the Supple hoses connecting the brake line to the caliper. You'll essential to modify the hose whether it is worn or has deteriorated.
3. Disconnect the brake path at the junction block that links it to the Supple brake hose and at the other end where it connects to remainder of the brake system. Use a flare-nut wrench on the fittings.
4. Connect the replacement brake line to both fittings. Up thrust the F150 Motor lorry with a floor jack and ease it on jack stands. Remove the rotate for the brake borderline you are changing.2.
Open the master cylinder in the engine compartment and top it off with brake fluid. Press the brake pedal several times to remove vacuum from the booster.
6. Fill a small bottle or similar container about a quarter full with brake fluid. Loosen the bleeder screw on the brake caliper slightly with a wrench and connect a clear tube to the screw fitting, submerging the tube's other end in the container.
7. Open the bleeder screw while a second person holds down on the brake pedal and look for air and fluid to enter the container. Tighten the screw when the fluid begins to slow. Repeat until only fluid comes out the tube.
8. Reconnect the wheel and lower the truck.
