Friday, December 12, 2014

Install Monitor Housing Inside Your Vehicle

Whether you demand to situate your machine video observer in a spot where Each in back can chronometer it, you should install monitor housing on the vehicle's interior roof. You then can effectiveness the recorder by connecting it to the wiring for the dome brilliant. Here's how.


Instructions


6. Attach the housing's mounting bracket to the roof's structural support. Use a power drill to drive the mounting bracket screws.


2. Haul down the vehicle's headliner (the textile covering the van's ceiling) sorrounding the installation globe by removing the snap clips, pushpins or screws that are holding it up.


3. Remove the dome flash by loosening the mounting screws with the Correct screwdriver. Detach the potentiality wires from the dome flare; you Testament utilize these for the video observer.


4. Compose a model on the headliner that matches, on the contrary is slightly smaller than, the monitor housing. Use a permanent marker and compare with the housing bracket to get the size right.


5. Use a box cutter to cut the hole that you marked for the monitor housing in the headliner. Stay inside the pattern, or your hole will be larger than the housing unit and leave gaps in the fabric.


1. Disconnect the battery cables from the battery using a wrench or socket. Trial the vehicle's repair notebook for the Correct baggage amount. Note: consider attaching a board to the roof first, using silicone and double-stick tape, so the mounting bracket screws don't go through the roof.


7. Attach the housing to the mounting bracket, using the screws supplied with the unit and following the installation instructions that came with it.


8. Reattach the headliner using the pushpins or screws you pulled out earlier.


9. Install the monitor you want to use in the monitor housing. Follow the installation instructions that came with it. Reconnect the car battery.