Installing a contemporary starter in your Toyota Corolla may emerge as exigent provided the full of years one starts to grind, turn slowly or stops working entirely. The starter can be tested once you remove it from the van, so provided you suspect something else is bad, own the starter tested at your community parts store to arbitrate if it needs to be replaced or not. Most auto-parts stores inventory replacement starters for the Toyota Corolla provided you complete you duty one.
Instructions
1. Free the hood and set the negative battery cable at the battery terminal. Loosen the clamp bolt on the cable with a wrench, then lift the cable off the battery.
2. Stand the front of your Corolla with a jack and block it with a locate of jack stands for safety. Slide under the front of the motorcar and remove the right-side under engine guard. Set the electrical connections on the starter solenoid and unplug the "S" connexion by miserable the locking tab and pulling it straight away.
3. Establish the retaining bolt on the "B" connexion and remove it with a wrench, then remove the cable from the starter. Movement to the front of the starter and good buy the two retaining bolts.
4. Remove the retaining bolts with a socket and ratchet, then lower the starter outside of the engine compartment. Push the electrical connection into the "S" terminal until it snaps in, then install the "B" cable onto the "B" terminal, followed by the retaining bolt. Tighten the retainer to 47 inch-pounds with a toque wrench.6. Raise the front off the car off the jack stands, remove them from under the car and lower it to the ground.
Hoist the fresh starter into position, slide the nose into the ring housing and install the two mounting bolts. Tighten the bolts to 27 foot-pounds with a torque wrench.5.
Remove the jack from under the car, then install the negative battery cable on the negative battery terminal. Tighten the retaining bolt with a wrench.
