2. Remove the front fender on the Polaris using a Philips screwdriver. Two screws are located on Everyone side of the fender, with a fifth screw located at the top of the fender.3. For starter troubleshooting purposes on the Polaris 400, one should research the battery cable connectivity, and Disinfected any corrosion on and encompassing the battery and cables before removing the starter.
Instructions
1. Compass the Polaris 400 all-terrain vehicle on exact ground and allot the parking brake.
The electrical development of the Polaris 400 all-terrain vehicle (ATV) consists of the charging, ignition, starting and lighting systems. The starter course consists of the starter Engine and attached starter solenoid. It receives capacity from the ignition method which receives its energy from the charging operation.
Disconnect the bad battery cable using a socket wrench. Deal in the edge of the cable absent from metal to prevent an inadvertent Glimmer.
4. Pull back the rubber boot from the electrical connector. It's connected to the starter Engine. Using a socket wrench, remove the exposed peanut, and disconnect the starter cable.
5. Remove the mounting bolt on the left side of the starter using a socket wrench. The antagonistic battery cable is connected to the mounting bolt. Disconnect the denying cable.
6. Remove the final mounting bolt using a socket wrench. Pull the starter to the left, and then out of the Polaris 400.
